Frequently Asked Questions
What happens if the machine jams?
A jam stops the feeder automatically. If delivery becomes messy, a protection switch stops the feeder as well: about ten sheets pass over the delivery bridge, then no more paper is fed, and the sheets already fed run through.
How is the UV oil supplied?
By a pneumatic diaphragm pump. We recommend 1–2 extra pump sets so you can change between different UV oils.
What plates are used?
Flexo resin plates and rubber blankets, 1.1–1.9 mm thick. Use a resin plate when you need accurate registration, and a rubber blanket for full coating. Plates clamp quickly.
How long do the UV lamps last?
1,000 hours. One UV unit has 3 UV lamps.
How does the paper travel through the UV unit?
Before coating, the sheet is carried by grippers. After coating, it travels on a mesh belt.
What is swing-up feeding?
The feeder uses an upper-swing feeding system. It gives more accurate registration, low noise, stable running, long service life, a low fault rate and high speed.
Is there double-sheet detection?
Yes. The infeed unit has a double-sheet detection alarm — if two sheets arrive together, it warns.
What coating unit is fitted as standard?
A standard rubber roller and steel roller, with a coating weight of 5–8 g/m². The exhibition configuration uses a ceramic anilox roller (200 LPI) with an enclosed doctor blade, low-odour UV oil and water-based tactile oil.
How many UV and IR units are there?
1 UV unit, controlled from the panel beside the delivery unit, and 2 IR units, controlled from the panel beside the feeding unit.
Request a Quotation — tell us your sheet size, paper thickness and whether you need spot or full UV coating. No prices are listed on this site; every machine is quoted on request.